Nine wrong decoration methods of new houses that a

2022-07-22
  • Detail

Abstract: for room decoration, it is not allowed to pierce holes in the load-bearing wall, dismantle the wall connecting the balcony and doors and windows, expand the size of the original doors and windows, or build additional doors and windows. This practice will cause local cracks in the building and seriously affect the seismic capacity, thus shortening the service life of the building

in the decoration project, the following points should be paid attention to:

first, the decoration of balcony and toilet should try to use materials with small load, because excessive overload of balcony will overturn

second, when decorating the room, it is not allowed to punch holes in the load-bearing wall, dismantle the wall connecting the balcony and doors and windows, expand the size of the original doors and windows, or build additional doors and windows. This practice will cause local cracks in the building and seriously affect the seismic capacity, thus shortening the service life of the building

III. in home decoration, it should be noted that the floor of the building should not be completely paved with marble. The weight of marble is dozens of times higher than that of floor tiles and wooden floors. If the ground is completely paved with marble, it may make the floor overburdened. Especially on the second floor and above, the weight of floor decoration materials shall not exceed 40 kg/m2 for house decoration that has not been identified by the house safety appraisal station

IV. waterproofing of toilet and bathroom is also a key link in decoration. The general practice is to plug the floor drain before decorating the toilet and bathroom, put more than 5cm of water, and conduct the water pouring test. If it leaks, it must be waterproof again; If there is no leakage, it is also necessary to carefully lay the ground during construction, and do not damage the waterproof layer and arbitrarily change the plumbing and heating system

v. during construction, attention should be paid to avoiding drilling holes, drilling holes, hanging ceilings and installing artistic lighting fixtures on the concrete circular orifice plate

VI. when selecting wires, use copper wires instead of aluminum wires. Due to the poor conductivity of aluminum wire, the wire is easy to heat, loose joints and even cause fire. In addition, during construction, attention should be paid not to directly dig slots and bury wires on the wall, but to adopt formal casing installation to avoid leakage and fire

VII. In order to pursue luxury in room decoration, the four walls are covered with plates, and the ceiling is inlaid with twoorthree layers of three-dimensional ceiling. This kind of decoration practice is not desirable. Because the four walls are covered with plates, it takes up a large space, which will reduce the area of the whole space, and the cost is also high, which is not conducive to fire prevention. Too low ceiling will make the whole room feel depressed

VIII. Indoor decoration should ensure the safety requirements of gas pipelines and equipment, and do not dismantle or modify pipelines without authorization, so as not to affect the normal operation of the system. In addition, it should be noted that the horizontal clear distance between power pipelines and equipment and gas pipelines should not be less than 10 cm, and the cross clear distance between wires and gas pipelines should not be less than 3 cm

IX. during kitchen decoration, do not put the gas stove on the wooden floor cabinet, and do not wrap the main gas valve in the wooden floor cabinet. Once the ground tank catches fire, the main gas valve will be difficult to close in the fire, and the consequences will be unimaginable

兰州银屑病医院

长沙骨科医院

重庆精神医院

Copyright © 2011 JIN SHI